HPE ProLiant DL385 Gen11 - Results; Removing and replacing the universal media bay cage; Prerequisites; Procedure

ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the universal media bay cageRemoving and replacing the universal media bay cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
ProcedureProcedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. If installed, remove all drives from the 2 SFF stacked drive cage.
4. Power down the server.
5. If installed, open the cable management arm.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 105