HPE ProLiant DL385 Gen11 - Open the cable management arm; Procedure; Extend the server out of the rack; Prerequisites

Open the cable management armOpen the cable management arm
ProcedureProcedure
1. Press and hold the blue PUSHPUSH button on the retention bracket.
2. Swing the arm away from the rear panel.
Extend the server out of the rackExtend the server out of the rack
PrerequisitesPrerequisites
Before you perform this procedure, review the Rack warnings and cautions.
T-25 Torx screwdriver—This tool is required if the shipping screws located inside the chassis ears are secured.
About this taskAbout this task
WARNING:WARNING:
To reduce the risk of personal injury, be careful when pressing the server rail-release latches. The inner rails could pinch
your fingers.
ProcedureProcedure
1. If needed, loosen the shipping screws, and then use the chassis ear latches to slide the server out of the rack until the rail-release latches
are engaged.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 46