3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. If the server is in the rear 4 LFF drive configuration, remove the rear 4 LFF drive cage .
9. Remove the primary riser cage.
10. Unplug the USB device from the USB port.
ResultsResults
To replace the component, reverse the removal procedure.
HPEHPE NS204i Boot Device NS204i Boot Device replacement replacement
SubtopicsSubtopics
Removing and replacing the boot device cage assembly from NS204i-u + low-profile riser cageRemoving and replacing the boot device cage assembly from NS204i-u + low-profile riser cage
Removing and replacing the boot device cage assembly on top of the power supply cageRemoving and replacing the boot device cage assembly on top of the power supply cage
Removing and replacing the boot device cage assembly from the secondary three-slot riser cageRemoving and replacing the boot device cage assembly from the secondary three-slot riser cage
Removing and replacing a boot device carrier with a security cover installedRemoving and replacing a boot device carrier with a security cover installed
Removing and replacing a boot device carrier without a security cover installedRemoving and replacing a boot device carrier without a security cover installed
Removing and replacing a boot device drive with a security cover installedRemoving and replacing a boot device drive with a security cover installed
Removing and replacing a boot device drive without a security cover installedRemoving and replacing a boot device drive without a security cover installed
Removing and replacing the boot device cage assembly from NS204i-u + low-profile riserRemoving and replacing the boot device cage assembly from NS204i-u + low-profile riser
cagecage
To Next Page
Loading...
