HPE ProLiant DL385 Gen11 - Results; Removing and replacing the optical drive blank

3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Do one of the following:
a. Remove the air baffle.
b. Remove the midplane drive cage .
9. Remove the fan cage.
10. Remove the midwall bracket.
11. If the server is in the front SFF drive configuration, disconnect all cables from the drive backplane.
12. Disconnect the energy pack extension cable from the energy pack cable.
13. Remove the energy pack from the holder.
a. Press and hold the release latch (callout 1).
b. Lift the energy pack from the holder (callout 2).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the optical drive blankRemoving and replacing the optical drive blank
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 100