ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the front 2 SFF stacked drive backplaneRemoving and replacing the front 2 SFF stacked drive backplane
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
ProcedureProcedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. If installed, remove all drives from the 2 SFF stacked drive cage.
To Next Page
Loading...
