ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the serial portRemoving and replacing the serial port
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a hex screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION:
The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the server
when a port blank is removed without the corresponding I/O port option installed.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm.
To Next Page
Loading...
