10. If an expansion card with internal cables is installed on the riser, disconnect the cables from the card.
11. Remove the expansion card.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the GPU from the front GPU riser cageRemoving and replacing the GPU from the front GPU riser cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either a
riser slot blank or an expansion card installed.
To Next Page
Loading...
