HPE ProLiant DL385 Gen11 - Results; Removing and replacing an OCP slot blank; Prerequisites; About this task

9. Remove the security cover from the boot device riser cage.
Retain the screw and cover for future use.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing an OCP slot blankRemoving and replacing an OCP slot blank
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this taskAbout this task
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 139