4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel.
9. If the server is in the rear 4 LFF drive configuration, remove the rear 4 LFF drive cage .
10. (Optional) If installed, remove the secondary riser cage.
11. Disconnect the serial port from the system board .
12. Remove the serial port:
a. Remove the hex screws (callout 1).
Retain screws for future use.
b. Detach the serial port from the rear panel (callout 2).
To Next Page
Loading...
