HPE ProLiant Gen10

Re-entering a serial number
Use the Serial Number option to re-enter the server serial number after replacing the system board. This
value must match the serial number sticker located on the back of the chassis.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Advanced Options > Advanced Service Options > Serial Number.
2. Enter the serial number, and then press Enter.
3. Save the setting.
Re-entering a product ID
Use the Product ID option to re-enter the product ID after replacing the system board. This value must
match the product ID sticker located on the back of the chassis.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Advanced Options > Advanced Service Options > Product ID.
2. Enter the product ID, and then press Enter.
3. Save your setting.
Configuring advanced debug options
Prerequisites
Boot Mode is set to UEFI Mode.
Use Advanced Debug Options to control the output level of debug and POST boot progress messages.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Advanced Options > Advanced Debug Options.
2. Select settings.
• UEFI Serial Debug Message Level—Sets the level of debug messages output to the serial
console.
◦ Disabled
◦ Errors Only
◦ Medium
◦ Network
◦ Verbose
126 Re-entering a serial number