HPE ProLiant Gen10

• PCI Device Configuration Options
• Advanced Options
• Date and Time
• System Default Options
Using the iLO 5 Configuration Utility
iLO 5 Configuration Utility options
You can access the iLO 5 Configuration Utility from the physical system console, or by using an iLO 5
remote console session. The utility has the following options:
• Network Options
• Advanced Network Options
• User Management
• Setting Options
•
Set to factory defaults
• Reset iLO
• About
Network Options
• MAC Address (read-only)—Specifies the MAC address of the selected iLO network interface.
• Network Interface Adapter—Specifies the iLO network interface adapter to use.
◦ ON—Uses the iLO Dedicated Network Port.
◦ Shared Network Port—Uses the Shared Network Port. This option is only available on supported
servers.
◦ OFF—Disables all network interfaces to iLO.
• Transceiver Speed Autoselect (iLO Dedicated Network Port only)—Enables iLO to negotiate the
highest supported link speed and duplex settings when connected to the network.
This option is only available when Network Interface Adapter is set to ON.
• Transceiver Speed Manual Setting (iLO Dedicated Network Port only)—Sets the link speed for the
iLO network interface.
This option is only available when Network Interface Adapter is set to ON and Transceiver Speed
Autoselect is set to OFF.
• Transceiver Duplex Setting (iLO Dedicated Network Port only)—Sets the link duplex setting for the
iLO network interface.
This option is only available when Network Interface Adapter is set to ON and Transceiver Speed
Autoselect is set to OFF.
• VLAN Enable (Shared Network Port only)—Enables the VLAN feature.
18 Using the iLO 5 Configuration Utility