HPE ProLiant Gen10

When the Shared Network Port is active and VLAN is enabled, the iLO Shared Network Port becomes
part of a VLAN. All network devices with different VLAN tags will appear to be on separate LANs, even
if they are physically connected to the same LAN. This option is only available when Network
Interface Adapter is set to Shared Network Port.
• VLAN ID (Shared Network Port only)—When a VLAN is enabled, specifies a VLAN tag.
All network devices that you want to communicate with each other must have the same VLAN tag. The
VLAN tag can be any number between 1 and 4094. This option is only available when Network
Interface Adapter is set to Shared Network Port.
• DHCP Enable—Configures iLO to obtain its IP address (and many other settings) from a DHCP
server.
• DNS Name—Sets the DNS name of the iLO subsystem.
This name can only be used if DHCP and DNS are configured to connect to the iLO subsystem name
instead of the IP address.
• IP Address—Specifies the iLO IP address.
If DHCP is used, the iLO IP address is supplied automatically. If DHCP is not used, enter a static IP
address.
• Subnet Mask—Specifies the subnet mask of the iLO IP network.
If DHCP is used, the subnet mask is supplied automatically. If DHCP is not used, enter a subnet mask
for the network.
• Gateway IP Address—Specifies the iLO gateway IP address.
If DHCP is used, the iLO gateway IP address is supplied automatically. If DHCP is not used, enter the
iLO gateway IP address.
Configuring Network Options
Procedure
1. From the System Utilities screen, select System Configuration > iLO 5 Configuration Utility >
Network Options.
2. Select any of the Network Options, and then select a setting or enter a value for that option.
3. Save your settings.
Advanced Network Options
• Gateway from DHCP—Specifies whether iLO uses a DHCP server-supplied gateway.
• Gateway #1, Gateway #2, and Gateway #3—If Gateway from DHCP is disabled, specifies up to
three iLO gateway IP addresses.
• DHCP Routes—Specifies whether iLO uses the DHCP server-supplied static routes.
• Route 1, Route 2, and Route 3—If DHCP Routes is disabled, specifies the iLO static route
destination, mask, and gateway addresses.
• DNS from DHCP—Specifies whether iLO uses the DHCP server-supplied DNS server list.
• DNS Server 1, DNS Server 2, DNS Server 3—If DNS from DHCP is disabled, specifies the primary,
secondary, and tertiary DNS servers.
Configuring Network Options 19