HPE ProLiant Gen10

To stop blinking the LED, click Stop.
Setting bootable devices for Legacy Boot Mode
Setting the primary and secondary bootable devices (Legacy Boot Mode)
Procedure
1. From the System Utilities screen, select System Configuration > controller > Set Bootable
Device(s) for Legacy Boot Mode > Select Bootable Logical Drive > logical drive.
2. In the Logical Drive screen, select either of the following:
• Set as Primary Bootable Device
• Set as Secondary Bootable Device
Setting the number of OS bootable drives (Legacy Boot Mode)
Procedure
1. From the System Utilities screen, select System Configuration > controller > Set Bootable
Device(s) for Legacy Boot Mode > Number of OS bootable drives.
2. In the Number of OS bootable drives screen, specify the number of OS bootable drives.
3. Click Submit Changes.
Viewing and configuring NIC and FCoE settings
Use the System Configuration screens to view information about and configure installed system
devices, such as embedded NICs and FCoEs. Devices listed and configuration options available vary by
system.
Procedure
1. From the System Utilities screen, select System Configuration.
2. Select a device.
A System Configuration screen displays information about the embedded device.
3. View, select, or enter settings.
4. Save your settings.
One-Time Boot Menu
One-Time Boot Menu options
Use the One-Time Boot Menu to select a UEFI boot option for a one-time boot override. The option you
select does not modify your predefined boot order settings. If you use a USB key or virtual media through
the iLO Remote Console, exit and re-enter the System Utilities to refresh this menu so that the devices
appear.
Boot options include:
Setting bootable devices for Legacy Boot Mode 35