HPE ProLiant Gen10

a. VLAN Control—Select Enabled to enable VLAN tagging on all enabled network interfaces. This
setting is disabled by default.
b. VLAN ID—When VLAN Control is enabled, enter a VLAN ID between 1 and 4094.
c. VLAN Priority—When VLAN Control is enabled, enter a priority value of 0 to 7 for VLAN tagged
frames.
3. Save your changes.
Storage options
Enabling embedded chipset SATA controller support
Use the Embedded SATA Configuration option to enable embedded chipset SATA (Serial Advanced
Technology Attachment) controller support. You can select AHCI or HPE Smart Array S100i SR Gen10
SW RAID support. Make sure that you are using the correct operating system drivers for your selected
option.
CAUTION: Dynamic Smart Array is not supported when the boot mode is configured to Legacy
BIOS Mode. Enabling Dynamic Smart Array RAID results in data loss or data corruption on existing
SATA drives. Back up all drives before enabling this option. See your operating system
documentation before enabling SATA AHCI support to ensure your base media drivers support this
feature.
Prerequisites
• The correct operating system drivers for your selected option.
• Boot Mode is set to UEFI Mode.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Storage Options > SATA Controller Options > Embedded SATA Configuration.
2. Ensure that you are using the correct ACHI or RAID system drivers for your SATA option.
3. Select a setting.
• SATA AHCI Support—Enables the embedded chipset SATA controller for AHCI.
• Smart Array SW RAID Support—Enables the embedded chipset SATA controller for Dynamic
Smart Array RAID.
4. Save your setting.
Enabling SATA Secure Erase
Use the SATA Secure Erase option to control whether SATA Secure Erase functionality is supported.
This function prevents the Secure Freeze Lock command from being sent to SATA hard drives.
Storage options 87