Prerequisites
• The SATA controller on the hard drive is in ACHI mode.
• The hard drive supports the Secure Erase command.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Storage Options > SATA Controller Options > SATA Secure Erase.
2. Select a setting.
• Enabled—The Security Freeze Lock command is not sent to supported SATA hard drives, enabling
Secure Erase to function.
• Disabled—Disables Secure Erase.
3. Save your setting.
Setting the embedded storage boot policy
Use the Embedded Storage Boot Policy option to select the UEFI BIOS boot targets for embedded
storage controllers. By default, all valid boot targets attached to the storage controller are available to the
UEFI Boot Order list.
Prerequisites
Boot Mode is set to UEFI Mode.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Storage Options > Embedded Storage Boot Policy.
2. Select a storage controller.
3. Select a setting.
• Boot All Targets—All valid boot targets attached to the storage controller are available to the UEFI
Boot Order list.
• Boot Limit to 24 Targets—A maximum of 24 boot targets attached to the storage controller are
available to the UEFI Boot Order list.
• Boot No Targets—No boot targets attached to the storage controller are available to the UEFI
Boot Order list.
4. Save your setting.
Setting the PCIe storage boot policy
Prerequisite
Boot Mode is set to UEFI Mode.
Use the PCIe Storage Boot Policy option to select the UEFI BIOS boot targets for storage controllers in
PCIe slots.
88 Setting the embedded storage boot policy
To Next Page
Loading...
