HPE ProLiant Gen10

Setting Description
Logical Drive Label Use the default selection for the drive label or
enter a new label. The characters in the label can
be alphanumeric or spaces.
Strip Size/Full Stripe Size Strip size is the amount of data that is stored on
each physical drive in the array. The full stripe
size is the amount of data that the controller can
read or write simultaneously on all the drives in
the array. For RAID levels that support fault
tolerance through parity, the parity information is
calculated one full strip size at a time.
For hardware RAID, you can specify from 16KiB
up to 1024KiB, depending on the number of disks
and RAID level. The default value is all available
space.
For Smart Array S100i SW RAID, the minimum
size is 16KiB and the maximum size is up to
256KiB, depending on RAID level and device
type.
Size Values in decimal; minimum RAID size is 16 MiB.
Unit Size Logical drive unit size (MiB/GiB/TiB).
Acceleration Method Logical drive acceleration method (controller
cache or none).
5. Click Submit Changes.
6. Return to the main menu.
7. Click OK when prompted to save your changes.
8. Reboot the server.
Managing an array
Viewing logical drive properties
Procedure
1. From the System Utilities screen, select System Configuration > controller > Array
Configuration > Manage Arrays > array > List Logical Drives > logical drive > Logical Drive
Details.
2. In the Logical Drive Details screen, view the details.
Creating a logical drive
Procedure
1. From the System Utilities screen, select System Configuration > controller > Array
Configuration > Manage Arrays > array > Create Logical Drive.
2. In the Create Logical Drive screen, select the RAID level, and then click Proceed to next Form.
System Utilities main menu options 31