HPE ProLiant Gen10

Configuring HPE Scalable Persistent Memory
NOTE: When you enable HPE Scalable Persistent Memory, the following occurs:
• Advanced EEC Support is enabled
• Node Interleaving is disabled
• Extended Memory Test is disabled
• Memory Clear on Warm Reset is disabled
• Automatic Power-on is set to Always Power On
CAUTION: Changes to HPE Scalable Persistent Memory menu options results in fully reinitializing
all backup storage devices and losing all previous user data.
Prerequisites
Ensure that all requirements are met:
• The server supports HPE Scalable Persistent Memory.
• No other Persistent Memory options are enabled on the server.
• Two HPE Scalable Persistent Memory 800W Flex Slot Power Supply with Integrated 400W Battery
Backup Units are installed on the server.
• The server has the correct HPE Smart Memory DIMMs installed.
• The server has a System RAM greater than 8 GB.
• The server has supported backup storage devices installed.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Memory Options > Persistent Memory Options > Scalable Persistent Memory
Options.
2. View or configure:
• Enable or disable Functionality.
• Select Backup Storage Options to change these options.
• Select Recovery Options to change these options.
• Processors 1, 2: Spanned Persistent Memory: Displays the amount of spanned memory
available.
• Processors 1, 2: Spanned Logical NVDIMM: Specifies the amount of spanned memory you want
to use.
• Processor 1: Persistent Memory Available (GB): Displays the amount of memory available on
this processor that may be assigned as persistent memory.
Configuring HPE Scalable Persistent Memory 71