HPE ProLiant Gen10

Setting Description
Power Mode Options are:
• Maximum performance (default)—Power
savings options that affect performance are
disabled.
• Balanced—Use this setting to save power with
minimal effects on performance.
• Minimum power—When settings are selected
without regard to system performance,
maximum power savings is achieved.
NOTE: Hewlett Packard Enterprise
recommends the minimum power setting for
specific applications, but it is not appropriate
for most customers. Most applications will
suffer significant performance reduction.
Survival Mode Allows controller to throttle back dynamic power
settings to minimum when temperature exceeds
the threshold. This minimum setting allows the
server to run in most situations, but performance
might decrease.
3. Click Submit changes.
Configure arrays
Creating an array using UEFI System Utilities
When you create an array, you can select drives, specify RAID level, and configure array settings,
including strip size and logical drive size.
Procedure
1. From the UEFI System Utilities screen, select System Configuration ><controller name> > Array
Configuration > Create Array.
2. In the Create Array screen, select each drive that you want to include in the array and click Proceed
to next Form.
NOTE: SAS drives are not supported on the S100i SW RAID.
3. In the Set RAID Level screen, select the RAID Level from the drop-down menu and click Proceed to
next Form.
4. In the Set Logical Drive Configuration screen, specify the configuration settings or use the default
selection.
30 Configure arrays