HPE ProLiant Gen10

• Host Storage—Enables a user to configure the host storage settings.
• Recovery Set—Enables a user to manage the recovery install set.
NOTE: By default, the Recovery Set privilege is assigned to the default Administrator account. To
assign this privilege to another account, log into the iLO web interface with an account that already
has this privilege. This privilege is not available if you start a session when the system maintenance
switch is set to disable iLO security.
New User Information
• New User Name—Specifies the name that appears in the user list on the User Administration page.
It does not have to be the same as the Login Name. The maximum length for a user name is 39
characters. The user name must use printable characters. Assigning descriptive user names can help
you to easily identify the owner of each login name.
• Login Name—Specifies the name that must be used when logging in to iLO. It appears in the user list
on the User Administration page, on the iLO Overview page, and in iLO logs. The Login Name
does not have to be the same as the User Name. The maximum length for a login name is 39
characters. The login name must use printable characters.
• Password and Password Confirm—Sets and confirms the password that is used for logging in to
iLO. The maximum length for a password is 39 characters. Enter the password twice for verification.
Adding new user accounts
Procedure
1. From the System Utilities screen, select System Configuration > iLO 5 Configuration Utility >
User Management > Add User.
2. Select any of the iLO 5 user privileges.
3. For each option, select one of the following settings.
• YES —Enables the privilege for this user.
• NO—Disables the privilege for this user.
4. Select a New User Information entry.
5. Complete each entry for the new user.
6. Create as many user accounts as needed, and then save your settings.
Edit/Remove User
Use this option to edit iLO user account settings, or to delete user accounts.
Editing or removing user accounts
Procedure
1. From the System Utilities screen, select System Configuration > iLO 5 Configuration Utility >
User Management > Edit/Remove User.
2. Select the Action menu for the user account you want to edit or delete.
Adding new user accounts 21