HPE ProLiant Gen10

Selecting the Removable Flash Media Boot Sequence
Use the Removable Flash Media Boot Sequence option to select which USB or SD card devices to
search first when enumerating boot devices.
Prerequisites
Boot mode is set to Legacy BIOS Mode.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > System Options > USB Options > Removable Flash Media Boot Sequence.
2. Select a setting.
• Internal SD Card First—Boots using the internal SD card slot.
• Internal Drive Keys First—Boots using the internal USB drive keys.
• External Drive Keys First—Boots using external USB drive keys.
3. Save your setting.
Enabling or disabling the Internal SD Card Slot
Use the Internal SD Card Slot option to control whether the server can access the SD (Secure Digital)
nonvolatile flash memory card that is embedded on the system board.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > System Options > USB Options > Internal SD Card Slot.
2. Select a setting.
• Enabled—The server can access the internal SD card slot.
• Disabled—The server cannot access the internal SD card slot.
3. Save your setting.
Configuring Server Availability
Enabling or disabling ASR
Prerequisite
The System Management driver is loaded.
Use the ASR Status option to enable or disable Automatic Server Recovery, which automatically reboots
the server if the server locks up.
Selecting the Removable Flash Media Boot Sequence 57