HPE ProLiant Gen10

Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > System Options > Server Availability > ASR Status.
2. Select a setting.
• Enabled
• Disabled
3. Save your setting.
Setting the ASR timeout
Prerequisite
ASR Status is enabled. Use the ASR Timeout option to set the time to wait before rebooting the server if
an operating system crash or server lockup occurs. When the server has not responded in the selected
amount of time, the server automatically reboots.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > System Options > Server Availability > ASR Timeout.
2. Select a wait time.
• 5 Minutes
• 10 Minutes
• 15 Minutes
• 20 Minutes
• 30 Minutes
3. Save your setting.
Enabling or disabling Wake-On LAN
Use the Wake-On LAN option to enable or disable the ability of the server to power on remotely using a
WOL-capable NIC.
Prerequisite
A WOL-capable NIC, NIC driver, and operating system
NOTE: If you enable this option, remove all power cords before adding or removing any adapters. Some
adapters can cause the system to power on when added or removed.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > System Options > Server Availability > Wake-On LAN.
2. Select a setting.
58 Setting the ASR timeout