HPE ProLiant Gen10

NOTE: This setting overrides the Fibre Channel/FCoE Scan Policy setting for Fibre Channel controllers in
PCIe slots.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Storage Options > PCIe Storage Boot Policy.
2. Select a storage controller.
3. Select a boot target.
4. Save your setting.
Changing the default Fibre Channel/FCoE scanning policy
Prerequisite
Boot Mode is set to UEFI Mode.
Use the Fibre Channel/FCoE Scan Policy option to change the default policy for scanning for valid FC/
FCoE (or boot from SAN) boot targets. By default, each installed FC/FCoE adapter only scans targets
that are preconfigured in the device settings. For Fibre Channel controllers in PCIe slots, this setting is
overridden by the PCIe Storage Boot Policy setting.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Storage Options > Fibre Channel/FCoE Scan Policy.
2. Select a setting.
• Scan All Targets—Each installed FC/FCoE adapter scans all available targets.
• Scan Configured Targets Only—Each installed FC/FCoE adapter only scans targets that are
preconfigured in the device settings. This setting overrides any individual device settings configured
in the device-specific setup.
3. Save your setting.
Enabling or disabling Embedded NVM Express Option ROM
Use the Embedded NVM Express Option ROM option to control how the NVM Express Option ROM is
loaded.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Storage Options > NVM Express Options > Embedded NVM Express Option ROM.
2. Select a setting.
Changing the default Fibre Channel/FCoE scanning policy 89