HPE ProLiant Gen10

• HTTPs only—Automatically adds HTTPS boot options to the UEFI Boot Order list for every
network port that is enabled for Network Boot. Enables the system to boot to the HTTPS URLs
provided by the DHCP server, and to ignore any HTTP or other URLs that are provided.
• Disabled
3. Save your changes.
Setting the iSCSI policy
Use the iSCSI Policy option to control which initiator is used for iSCSI boot on configured NIC ports.
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Network Options > Network Boot Options > iSCSI Policy.
2. Select a setting.
• Software Initiator—Enables the UEFI iSCSI software initiator.
• Adapter Initiator—Disables the UEFI iSCSI software initiator and only uses the adapter specific
iSCSI initiator.
NOTE: To enable iSCSI boot from the adapter initiator, you must enable iSCSI in the adapter
firmware and configure it.
3. Save your changes.
Configuring Pre-Boot Network Settings
Procedure
1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Network Options > Pre-Boot Network Settings.
2. Select any of the Pre-boot Network Settings options.
3. Select additional settings or enter additional values for that option.
4. Save your changes.
More information
Pre-Boot Network Settings on page 83
Pre-Boot Network Settings
Use this option to configure a preboot network interface and related settings.
Setting the iSCSI policy 83