10. Do one of the following:
Orient the server back in tower mode.
Install the server into the rack.
11. Connect all peripheral cables to the server.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server.
Processor replacementProcessor replacement
SubtopicsSubtopics
Processor cautionsProcessor cautions
Removing the processorRemoving the processor
Installing the processorInstalling the processor
Processor cautionsProcessor cautions
CAUTION:CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or
install the processor in this server.
CAUTION:CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor configurations must
contain processors with the same part number.
CAUTION:CAUTION: The pins on the processor socket and on the processor are very fragile and easily damagedThe pins on the processor socket and on the processor are very fragile and easily damaged . To avoid component
damage, do not touch these pinsdo not touch these pins. Any damage to them might require replacing the system board and/or processor.
IMPORTANT:IMPORTANT: Processor socket 1 must be populated at all times or the server does not function.
IMPORTANT:IMPORTANT: If installing a processor with a faster speed, update the system ROM before installing the processor. To
download firmware, see Updating firmware or system ROM .
Removing the processorRemoving the processor
PrerequisitesPrerequisites
Identify the heatsink and processor socket components .
Review the processor cautions .
Before you perform this procedure, make sure that you have the following items available:
T-30 Torx screwdriver
Alcohol wipe
To Next Page
Loading...
