ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a DIMM guardRemoving and replacing a DIMM guard
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel.
6. Remove the fan cage.
7. Remove the DIMM guard.
Left
Right
To Next Page
Loading...
