Installing the system board assemblyInstalling the system board assembly
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-30 Torx screwdriver
T-15 Torx screwdriver
Thermal grease (spare part number: 777298-001)
Hex screwdriver—This tool is required only if the serial port cable is to be installed.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Position the new system board over the alignment tabs on the chassis.
To Next Page
Loading...
