ResultsResults
To replace the component, reverse the removal procedure.
Media device replacementMedia device replacement
SubtopicsSubtopics
Removing and replacing the USB RDX docking stationRemoving and replacing the USB RDX docking station
Removing and replacing the optical driveRemoving and replacing the optical drive
Removing and replacing the USB RDX docking stationRemoving and replacing the USB RDX docking station
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
ProcedureProcedure
1. Remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
To Next Page
Loading...
