ItemItem DescriptionDescription
1 NS204i-u device slot 1 (optional)
2 NS204i-u device slot 2 (optional)
3 Flexible Slot power supply 1
4 Slots 9–10 PCIe5 x8 (tertiary riser)
5 Flexible Slot power supply 2 (optional)
6 VGA port
7 Slot 15 OCP PCIe5 x16
8 Serial port (optional)
9 iLO management port
10 USB 3.2 Gen 1 ports (2)
11 Slot 14 OCP PCIe5 x16
12 Slots 1–4 PCIe5 (primary riser)
13 Padlock eye
14 Slots 5–8 PCIe5 (secondary riser)
15 Kensington slot
Two processors are required for installing the secondary riser option. The same is required for a tertiary riser option used for NIC card
installation.
This slot supports an OCP NIC adapter.
This slot supports an OCP NIC adapter or a type-o storage controller.
Primary/secondary riser cage supports two riser boards.
SubtopicsSubtopics
Display device setupDisplay device setup
Display device setupDisplay device setup
This server supports both VGA port and DisplayPort 1.1a. Before connecting a display device to this server, review the information below.
Whenever possible, use the same display connection type. For example, if your PC or monitor only has a VGA output, connect it to the
server VGA port. Use of any kind of adapter or converter cable or dongle might lead to decreased display quality or a lag over the
connection.
DisplayPort connection: When connecting an HDMI or DVI display to the DisplayPort, use an active type adapter. Passive type adapter—
marked with the DP++ symbol—is not supported.
Display output modes:
If you connect two display devices to the VGA port and DisplayPort, the same image is shown on both devices—screen mirroring
mode.
The embedded video controller in the iLO 6 chipset does not support dual display or screen extension mode. To enable dual display
mode, install a compatible PCIe graphics card that supports this feature in the expansion slot.
Rear panel LEDsRear panel LEDs
1
2
3
4
1
,
4
1
2
3
4
To Next Page
Loading...
