15. Use an alcohol wipe to remove the existing thermal grease from the heatsink and processor.
Allow the alcohol to evaporate before continuing.
Installing the heatsinkInstalling the heatsink
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-30 Torx screwdriver available.
About this taskAbout this task
Processors with TDP equal to or greater than 195 W require performance heatsinks.
ProcedureProcedure
1. CAUTION:CAUTION:
THE PINS ON THE PROCESSOR SOCKET AND ON THE PROCESSOR ARE VERY FRAGILE AND EASILY DAMAGED.THE PINS ON THE PROCESSOR SOCKET AND ON THE PROCESSOR ARE VERY FRAGILE AND EASILY DAMAGED. Any
damage to them might require replacing the system board.
Do not touch the pins on the processor socket and the processor.
To Next Page
Loading...
