ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
5. If the server is in rack mode, do one of the following:
Extend the server from the rack .
Remove the server from the rack .
6. Remove the access panel.
7. Disconnect the boot device signal and power cables from the system board .
8. Remove the boot device from the top of the power supply cage:
a. Pull and hold the latch (callout 1).
b. Remove the boot device from the chassis side wall (callout 2).
9. Disconnect the signal and power cables from the boot device.
10. Remove the boot device baffle:
a. Remove the air baffle screws (callout 1-2).
b. Remove the baffle from the boot device (callout 3).
To Next Page
Loading...
