ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the internal USB deviceRemoving and replacing the internal USB device
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
5. If the server is in rack mode, do one of the following:
Extend the server from the rack .
Remove the server from the rack .
6. Remove the access panel.
7. Unplug the USB device from the USB port.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the energy packRemoving and replacing the energy pack
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
To Next Page
Loading...
