2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel.
6. Open the cable clamp.
7. Release all cables from the clamp.
8. Remove the cable clamp:
a. Press and hold the latch (callout 1).
b. Slide the clamp up to remove it from the chassis (callout 2).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the Removing and replacing the boot deviceboot device security cover security cover
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
To Next Page
Loading...
