Pre-8
INTELLIGENT ACTUATOR
CE Mark
1. EC Directives
The EC Directives are a new set of directives issued by the European Commission that are intended to
protect the health and safety of users and consumers of products distributed within the EU (European
Union) zone, while ensuring free movements of these products within the EU zone. Companies exporting
to Europe or having a production facility in Europe must comply with the following directives in order to
receive a CE Mark certification for their products.
(1) Low-voltage Directive
The X-SEL-P/Q controllers are designed to comply with the Low-voltage Directive on their own.
(2) EMC Directives
The EMC Directives must be met by the entire equipment, or a combination of IAI’s controller and
other control devices and electrical components used by the equipment. IAI’s approach is to
determine representative connection/installation models (conditions), each combining controller(s),
actuator(s) and peripheral(s), and ensure that each of these models complies with the EMC
Directives. (Refer to 3, “Peripheral Configurations.”)
2. Applicable Standards
<Low-voltage Directive>
EN50178 (Electronic equipment used in electrical installations)
<EMC Directives>
EN55011 (Radio interference characteristics of industrial, scientific and medical equipment
generating radio frequency)
EN61000-6-2 (Immunity in industrial environment)
EN61000-4-2 (Immunity to electrostatic discharge)
EN61000-4-3 (Immunity to electromagnetic field generated by irradiated radio frequency)
EN61000-4-4 (Electrical first transient/burst immunity test)
EN61000-4-5 (Surge immunity test)
EN61000-4-6 (Immunity test against conductive interference induced by radio-frequency
electromagnetic field)
EN61000-4-8 (Immunity test against power-frequency magnetic field)
EN61000-4-11 (Immunity test against voltage dip, momentary power failure and voltage
fluctuation)
To Next Page
Loading...
Need help?
General
