334
INTELLIGENT ACTUATOR
Part 5 Multi-Tasking
5. Program Switching
Various methods are available to switch between programs, depending on the purpose of programs. The
representative methods are explained below.
External start
Program switching
Program Single-tasking
EXIT command
Multi-tasking
EXPG command
First, the program switching methods are largely divided into switching by external start and switching by
application program.
(1) External start method
Refer to Chapter 1, “Operation” (Starting via External Signal Selection)
in Part 2, “Operation.”
(2) Program method
Single-tasking
Executing an EXIT command (end program) at the end of each program will end the program and
cause the system to return to the condition immediately after the power is turned on. However, since
the home position is retained, another program can be started by an external start input with the
corresponding program number specified.
Multi-tasking
Creating a management program and executing EXPG commands (start other program) will allow a
series of programs to be run in parallel.
To Next Page
Loading...
Need help?
General
