IAI X-SEL User Manual

281
INTELLIGENT ACTUATOR
Part 4 Commands
1.21 Palletizing Calculation Command
 PTNG (Get palletizing position number)
Command, declaration
Extension condition
(LD, A, O, AB, OB)
Input condition
(I/O, flag)
Command,
declaration
Operand 1 Operand 2
Output
(Output, flag)
Optional Optional PTNG
Palletizing
number
Variable
number
CP
Assign the palletizing position number for the palletizing number specified in operand 1 to the variable
specified in operand 2.
If the output field is specified, the output will turn ON after this command is executed.
 PINC (Increment palletizing position number by 1)
Command, declaration
Extension condition
(LD, A, O, AB, OB)
Input condition
(I/O, flag)
Command,
declaration
Operand 1 Operand 2
Output
(Output, flag)
Optional Optional PINC
Palletizing
number
Prohibited CC
Increment by 1 the palletizing position number for the palletizing number specified in operand 1.
If the incremented value is considered normal as a palletizing position number calculated under the
current palletizing setting, the value will be updated. If not, the value will not be updated.
If the output field is specified, the output will turn ON when the value was successfully incremented, and
turn OFF if the increment failed.

IAI X-SEL Specifications

General

Brand	IAI
Model	X-SEL
Category	Controller
Language	English