To Next Page

To Previous Page

Chapter 3. Graphical user interface overview 127

Clicking an existing partnership opens a window, as shown in Figure 3-78. From this window,

you can also set the background copy rate. This rate specifies the bandwidth, in Mbps, that is

used by the background copy process between the clusters (Figure 3-78). In our case, we

configured the partnership only on one side.

You can see it in the State row. It shows Partially Configured: Local, which is an indication

that the configuration was only configured on one side. If you see this message, go to the

second system, and configure the Create Partnership settings there, too.

Figure 3-78 Partnership properties

3.8 Access menu

The Access menu has two options:

򐂰 Users (for user management)

򐂰 Audit Log

Figure 3-79 shows these options.

Figure 3-79 Access menu

Other manuals for IBM Storwize V5030

Questions and Answers:

Need help?

Do you have a question about the IBM Storwize V5030 and is the answer not in the manual?

General