To Next Page

To Previous Page

410 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1

8.3.4 Viewing which host is mapped to a volume

To determine which host mappings are configured, complete the following steps:

1. Highlight a volume and select View Mapped Host from the Actions menu. The Host Maps

tab of the Volume Details panel opens, as shown in Figure 8-46. In this example, host

RHEL_HOST_1 is mapped to the RHEL_HOST_1_BOOT_VOL volume.

Figure 8-46 Volume to host mapping

2. To remove a mapping, highlight the host and click Unmap from Host. If several hosts are

mapped to this volume (for example, in a cluster), only the selected host is removed.

8.3.5 Renaming a volume

To rename a volume, complete the following steps:

1. Select Rename from the Actions menu. The Rename Volume window opens.

2. Enter the new name, as shown in Figure 8-47.

Figure 8-47 Renaming a volume

Other manuals for IBM Storwize V5030

Questions and Answers:

Need help?

Do you have a question about the IBM Storwize V5030 and is the answer not in the manual?

General