To Next Page

To Previous Page

246 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1

9. Click Add Host, and the wizard creates the host (Figure 5-49).

Figure 5-49 Add Host task completes

10.Click Close to return to the Hosts window. The host that was created shows up in the

hosts window, as shown in Figure 5-50.

Figure 5-50 Defined hosts

11.Repeat steps 1 to 10 for all of your Fibre Channel hosts. After you add all of the Fibre

Channel hosts, create volumes and map them to the created hosts. See Chapter 6,

“Volume configuration” on page 287.

5.5.2 Configuring the IBM Storwize V5000 for FC connectivity

You can configure the FC ports on the IBM Storwize V5000 for use for certain connections

only. This capability is referred to as

port masking. In a system with multiple I/O groups and

remote partnerships, port masking is a useful tool for ensuring peak performance and

availability.

Other manuals for IBM Storwize V5030

Questions and Answers:

Need help?

Do you have a question about the IBM Storwize V5030 and is the answer not in the manual?

General