To Next Page

To Previous Page

260 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1

This section describes the following host cluster operations using the GUI:

򐂰 Creating a host cluster

򐂰 Adding a member to the host cluster

򐂰 Listing a host cluster members

򐂰 Assigning a volume to the host cluster

򐂰 Unmapping a volume from the host cluster

򐂰 Removing a host cluster member

򐂰 Removing the host cluster

5.6.1 Creating a host cluster

To create a host cluster using the GUI, follow the steps listed.

1. Click Hosts → Hosts from the main panel as shown in Figure 5-73.

Figure 5-73 Host Clusters

Notes:

򐂰 From IBM Spectrum Virtualize V8.1.0 onwards, various Host Cluster-related

operations can also be done using the GUI in addition to CLI.

򐂰 Host clusters enable you to create individual hosts and add them to a host cluster. Care

must be taken to make sure that no loss of access occurs when transitioning to host

clusters.

Other manuals for IBM Storwize V5030

Questions and Answers:

Need help?

Do you have a question about the IBM Storwize V5030 and is the answer not in the manual?

General