To Next Page

To Previous Page

782 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1

4. After you click finish, the system will configure SKLM servers as a second encryption key

provider. Successful completion of the task is confirmed by a message (Figure 13-55).

Figure 13-55 Confirmation of successful configuration of two encryption key providers

5. You can confirm that encryption is enabled, as well as verify which key providers are in

use, by going to Settings → Security → Encryption, as shown in Figure 13-56. Note four

green check marks confirming that the master access key is available on all four SKLM

servers.

Figure 13-56 Encryption enabled with two key providers available

13.5.2 Adding USB flash drives as a second provider

If the storage system is already configured with an SKLM encryption key provider, it is

possible to configure USB flash drives as a second provider. To enable USB flash drives as a

second provider follow these steps:

Other manuals for IBM Storwize V5030

Questions and Answers:

Need help?

Do you have a question about the IBM Storwize V5030 and is the answer not in the manual?

General