Chapter 10. Copy services 515
In its basic mode, the IBM FlashCopy function copies the contents of a source volume to a
target volume. Any data that existed on the target volume is lost, and that data is replaced
by the copied data.
From the Copy Services option on the main panel, use the Consistency Groups option, as
shown in Figure 10-11. A
Consistency Group is a container for mappings. You can add
many mappings to a Consistency Group.
Figure 10-11 Consistency Groups pane
From the Copy Services option on the main panel, use the FlashCopy Mappings pane, as
shown in Figure 10-12. A
FlashCopy mapping defines the relationship between a source
volume and a target volume.
Figure 10-12 FlashCopy Mappings pane
10.4.1 Creating a FlashCopy mapping
In this section, we create FlashCopy mappings for volumes and their targets.
Complete the following steps:
1. From the main pane, move the mouse pointer over Copy Services click FlashCopy. The
FlashCopy pane opens, as shown in Figure 10-13.
Figure 10-13 FlashCopy pane
2. Select the volume for which you want to create the FlashCopy relationship (Figure 10-14).
Multiple FlashCopy mappings: To create multiple FlashCopy mappings at one time,
select multiple volumes by holding down Ctrl and clicking the entries that you want.
To Next Page
Loading...
Need help?
General
