784 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1
3. You can confirm that encryption is enabled, as well as verify which key providers are in
use, by going to Settings → Security → Encryption, as shown in Figure 13-59. Note four
green check marks indicating that the master access key is available on all four SKLM
servers.
Figure 13-59 Encryption enabled with two key providers available
13.6 Migrating between providers
IBM Spectrum Virtualize V8.1 introduced support for simultaneous use of both USB flash
drives and a key server as encryption key providers. The system also allows migration from
configuration using only USB flash drive provider to key servers provider and vice versa.
13.6.1 Migration from USB flash drive provider to encryption key server
The system is designed to facilitate migration from USB flash drives encryption key provider
to encryption key server provider. If you follow the steps described in 13.5.1, “Adding SKLM
as a second provider” on page 780, but when executing procedure step 2 on page 781 select
Yes instead of No (see Figure 13-60). This will cause de-activation of the USB Flash drives
provider, and the procedure will complete with a single active encryption keys provider –
SKLM server(s).
Figure 13-60 Disable USB Flash drive provider while migrating to SKLM provider
To Next Page
Loading...
Need help?
General
