To Next Page

To Previous Page

210 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1

3. Confirm the automatic start of the iSCSI service (Figure 5-11).

Figure 5-11 Automatic start of the iSCSI service

4. The iSCSI Initiator Properties window opens. Select the Configuration tab (Figure 5-12).

Write down the initiator name of your Windows host because you use it later.

Figure 5-12 iSCSI Initiator Properties window

5. You can change the initiator name, or enable advanced authentication, but these actions

are out of the scope of our basic setup. By default, iSCSI authentication is not enabled.

More details are available at the IBM Knowledge Center for the Storwize V5000 at the

following address:

https://ibm.biz/BdjSrz

6. From the Configuration tab, you can change the initiator name, enable CHAP

authentication, and more. However, these tasks are beyond the scope of our basic setup.

Other manuals for IBM Storwize V5030

Questions and Answers:

Need help?

Do you have a question about the IBM Storwize V5030 and is the answer not in the manual?

General