EasyManuals Logo

IBM Storwize V5030 User Manual

IBM Storwize V5030
864 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #800 background imageLoading...
Page #800 background image
778 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1
9. The next step in the wizard is to store the master encryption key copies on USB flash
drives. If there are fewer than three drives detected, the system will request plugging
additional USB flash drives as shown on Figure 13-47. You cannot proceed until the
required minimum number of USB flash drives is detected by the system.
Figure 13-47 At least 3 USB flash drives are required to configure USB flash drive key provider
10.When at least three USB flash drives are detected, the system will write master access
key to each of the drives. Note that the system will attempt to write the encryption key to
any flash drive that it detects. Therefore, it is crucial to maintain physical security of the
system during this procedure.After the keys are successfully copied to at least three USB
flash drives, the system displays a screen, as shown in Figure 13-48.
Figure 13-48 Master Access Key successfully copied to USB flash drives

Table of Contents

Other manuals for IBM Storwize V5030

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM Storwize V5030 and is the answer not in the manual?

IBM Storwize V5030 Specifications

General IconGeneral
ModelIBM Storwize V5030
CategoryStorage
Controller Enclosures1 or 2
Maximum Drives240
RAID Levels0, 1, 5, 6, 10
VirtualizationYes
Data CompressionYes
Maximum Hosts512
Form Factor2U
Drive TypesSAS, NL-SAS, SSD
Host Interface8 Gb FC, 16 Gb FC, 10 Gb iSCSI, 12 Gb SAS
Processor Cores8 per controller

Related product manuals