Icom ID-5100A

13
OTHER FUNCTIONS
13-19
Remote jack (CI-V) information (Continued)
•DVTXcallsignssetting(24characters)
Command: 1F 01
Set “UR,” “R1” and “R2” call signs of 8 characters
(fixed).
XX
• • •
XX XXXX X XXX
• • •
!7–@4o–!6q–i
• • •
q–i: UR (Destination) call sign setting (8 charac-
ters)
o–!6: R1 (Access/Area repeater) call sign setting (8
characters)
!7–@4: R2 (Link/Gateway repeater) call sign setting
(8 characters)
•Character’scodeofthecallsign
Character ASCII code
0–9 30–39
A–Z 41–5A
(Space) 20
/ 2F
•DVTXmessagesetting
Command: 1F 02
Set the transmit message of up to 20 characters.
“FF” stops sending or reading messages.
Character ASCII code Character ASCII code
A–Z 41–5A a–z 61–7A
0–9 30–39 Space 20
! 21 # 23
$ 24 % 25
& 26 \ 5C
? 3F " 22
’ 27 ` 60
^ 5E + 2B
– 2D
Q
2A
/ 2F . 2E
, 2C : 3A
; 3B = 3D
< 3C > 3E
( 28 ) 29
[ 5B ] 5D
{ 7B } 7D
¦ 7C _ 5F
¯ 7E @ 40
•DVRXcallsigndata
Command: 20 0001, 20 0002
q Headeragdata (First byte)
Data Description
bit7 (0 :Fixed) —
bit6 (0 :Fixed)
bit5 (0 :Fixed)
bit4 0/1 0=Voice, 1=Data
bit3 0/1 0=Direct, 1=Through repeater
bit2 0/1 0=No Break-in, 1=Break-in
bit1 0/1 0=Data, 1=Control
bit0 0/1 0=Normal, 1=EMR
w Headeragdata (Second byte)
Data Description
bit2 bit1 bit0
1 1 1 Repeater control
1 1 0 Send auto acknowledge
1 0 1 (Not used)
1 0 0 Request to re-transmit
0 1 1 Send acknowledge
0 1 0 Receive no reply
0 0 1 Repeater disabled
0 0 0 NULL
e–!0: Call sign of the caller station (8 characters;
fixed)
!1–!4: Note of the caller station (4 characters; fixed)
!5–@2: Call sign of the called station (8 characters;
fixed)
@3–#0: Call sign of the access/area repeater (R1) (8
characters; fixed)
#1–#8: Call sign of the link/gateway repeater (R2) (8
characters; fixed)
• “ FF” stands for no call sign receiving after turning ON the
transceiver.
Previous view