Auto Sentry® flex User Manual 100 Service Unit Screen
Remove Bill or Coins (from the Auto Sentry)
Selecting the Remove command tells the software to zero out the amount (or quantity in the case
of tokens) at the selected device. This automatic journal entry is entered in the WashConnect®
software. The command does not physically cause bills or coins to be dispensed from the device.
You must manually remove the bills or coins after completing the Remove command.
Removing from Bill Dispenser, Bill Acceptor, or Coin Acceptor
NOTE: When the user removes money from the Auto Sentry, they will have to verify the journal
entry associated with the remove because it is not Auto Verified.
To remove funds from the bill dispenser, bill acceptor, or coin acceptor, follow these steps:
1 Log on the Service Unit Screen of the Auto Sentry.
2 On the Service Unit Screen, tap an icon.
Figure 74. Service Unit Screen Icons
3 Tap Remove, and then tap Start. A message appears in the information box. For example, 600
bills removed from Bill Dispenser.
4 Slide out the bill dispenser, bill acceptor or coin acceptor drawer. Collect the bills or coins, and
then slide the drawer back.
Removing from Coin Hopper or Coin Token Hopper
To remove coins from the coin hopper or coin token hopper, follow these steps:
Part One: Verify the Hopper
1 Log on the Service Unit Screen of the Auto Sentry.
2 On the service unit screen, select a coin hopper or coin token hopper icon.
BILL DISPENSER
BILL ACCEPTOR
COIN ACCEPTOR
To Next Page
Loading...
General