Auto Sentry® flex User Manual 93 Service Unit Screen
Chapter 3:
Service Unit Screen
You can use the Service Unit screen to add and remove money from the bill dispenser or coin
hoppers; remove money from the bill or coin acceptors; and verify the coin hoppers. This screen
will be directly accessible on the Auto Sentry touch screen.
Add—Adds bills to the dispenser or coins to the hopper.
Remove—Take funds from the unit.
Verify—Empty selected coin hopper and get a count of coins dispensed.
Close Terminal—Close the current terminal upon exiting the Service Unit screen. The unit
displays the message Car Wash Is Closed.
Diagnostics—Offers a receipt printer test and a dispense test for the bill and coin dispensers.
Also displays Bill Dispenser Diagnostics and History, as well as a listing of current Software
Revisions. If set up, disable or reset Vandalism Alarm from this screen.
Service Unit Screen Password and PIN
To access the Auto Sentry® flex service screen, a user password and PIN must be created. You can
create the password and PIN in the User dialog box.
To create a password and PIN, follow these steps:
1 In WashConnect®, on the Users menu, click Manage Users.
The Manage Users tab appears.
2 Select a User, and then click the Edit button.
The User dialog box appears.
3 In the Password box, type an alphanumeric password.
NOTE: This is an alphanumeric password can be upper and lower case letters with numbers and
symbols if the user would like to use them. Must be at least six characters long.
4 In the PIN box, type a four-digit PIN.
To Next Page
Loading...
General