Auto Sentry® flex User Manual 102 Service Unit Screen
The Close Terminal button is used when closing the wash at the end of business to prevent
customers from attempting to purchase a wash. A message will be displayed on the screen to
indicate that the Wash is Closed.
NOTE: The Close Terminal button simply stops access to the terminal to prevent wash
purchases. It does not close the wash shift. WashConnect® will automatically close the
shift each night at midnight.
Bump Shift
You can manually close a shift at the Auto Sentry® flex®.
For example, you might service the WashConnect® in the middle of the day by removing all the
cash and replacing the bill dispenser with a fresh cassette. At this point, you might want to create
a new shift for the WashConnect®. You can use the Bump Shift button at the Auto Sentry® flex® to
create a new shift.
To close a shift, follow these steps:
1 Log on the Service Unit Screen of the Auto Sentry.
2 In the Site ID box, select a Site ID, which is typically a four-digit number such as 1002.
3 Log on with your user ID / four-digit PIN, and then tap Enter.
4 Tap Bump Shift.
The following message appears:
“Attempting to bump shift . . ."
"New shift [nnnn] Created Successfully”
You can see the new shift in the Journals dialog box and the shift report screen.
Close Terminal
Select the Close Terminal button or use the override switch if installed at the facility.
To Next Page
Loading...
General