ICS Auto Sentry flex User Manual

Auto Sentry® flex User Manual 103 Service Unit Screen
Open Terminal
Select the Open Terminal button or use the override switch if installed at the facility.
Diagnostics
The diagnostics screen displays information about the bill dispenser. You can also test the printer
and issue a dispense command to the bill dispenser and coin hoppers.
Table 1: Diagnostics Screen Icon Descriptions
Tap the Tes t button to print a test receipt.
Tap the bill dispenser, coin, or token hopper,
and then tap the Dispense button. A single
bill or coin is ejected from the device. This is
not recorded in the software. You should
replace the bill or coin after it has been
dispensed.
Tap the Refresh button to redisplay the
dispenser diagnostics. This will take another
reading of all the sensors and display the
health again.
Tap the Exit button to leave the diagnostics
screen.
Tap the Clear Memory button (DeLaRue
®
bill
dispensers only). Clears bill calibration
settings. Unit will need to be reprogrammed
to learn bills.
Tap the Lock button (DeLaRue bill dispensers
only). Physically locks the cassette so it
cannot be removed.

ICS Auto Sentry flex Specifications

General

Brand	ICS
Model	Auto Sentry flex
Category	Washer
Language	English