Auto Sentry® flex User Manual 22 Introduction
Safe Configuration
You can use the optional safe with the ICS WashConnect cash management system.
NOTE: If you are a new customer, you will need to make a choice about whether the safe is
enabled or disabled for your site. ICS recommends using the safe. Discuss with your ICS
service technician during your installation for more information.
The safe is a software-based repository of the reserve cash, coins, checks, token notes and token
coins at your site, which are not currently in circulation at each attended and unattended terminal.
Enabling or Disabling the Safe
If you are a new ICS customer, then before you begin using your Auto Sentry® flex and cash
management software, you will decide to enable or disable the safe. In either case, you can use
cash management software to monitor the liquidity (cash on hand) at your site across devices.
If you enable the safe, you can monitor total liquidity.
If you disable the safe, you cannot monitor total liquidity for all devices. Some additional
record keeping will be necessary.
Flex-Serve Facilities with the Safe
If you are a flex-serve facility, you can configure your Auto Sentry® flex to use the safe. This is
shown on the left-half of the diagram below.
The safe can be disabled for the POS and Touch IT devices at your site. This is shown in the right-
half of the diagram below.
To Next Page
Loading...
General